Mercedes C-Class

W203 since 2000 of release

Repair and operation of the car


Mercedes-Benz
+ Mercedes-Benz cars of class C (W-203)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   + Suspension bracket of forward wheels
   + Suspension bracket of back wheels
   + Angles of installation of wheels of the car
   - Steering and safety cushions
      Steering and safety cushions - general information and security measures
      Security measures during the works with a safety cushion
      Removal and installation of the block of a safety cushion on a steering wheel
      Removal and installation of a steering wheel
      Removal and installation of a tip of steering draft
      Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment



Removal and installation of the block of a safety cushion on a steering wheel

Safety cushions

1 — the Safety cushion of the driver
2 — the Safety cushion of the forward passenger
3 — a head Safety cushion 		4 — the Side safety cushion back
5 — the Side safety cushion forward

Removal

 PERFORMANCE ORDER

Get acquainted with security measures at the address with a safety cushion.

Illustrations have informative character and cannot correspond to completely considered model.

1. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery.

2. Isolate both poles of the rechargeable battery to exclude a possibility of casual contact.
3. Completely extend a steering wheel for what release the lock lever.

4. Turn out through openings on a steering wheel (1) two screws with an internal hexagon on 30 mm from within, holding at the same time the safety cushion block.

On an illustration the block of a safety cushion is already removed. (2) – switch of the index of turn.

5. Remove the block of a safety cushion (3) from a steering wheel and disunite the socket (4) fuses.

6. Put the safety cushion block so that the pillow of a steering wheel looked up.

Do not leave the safety cushion block without supervision, if necessary move away him and close.


Installation

 PERFORMANCE ORDER

1. Put the safety cushion block on a steering wheel and fix the socket so that the distinct click was heard.
2. Grease fastening bolts with a compound for fixing of threaded connections and tighten the moment 6 Nanometers.
3. Attach a cable of mass of the rechargeable battery at the switched-off ignition. Install into place a box of the filter of air of salon. If it is necessary, enter a code of the radio receiver and determine time on hours.