Mercedes C-Class

1. Lift a forward part of the car and establish it on supports.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

2. Turn out 3 bolts of fastening (1) and take out razzhimny a clip (2).

3. Take out 4 razzhimny clips (1) from a front bumper.

4. Take out a forward loker of a wing from a wheel arch.

1. Installation is carried out in the sequence, the return to removal.
2. Lower the car on wheels.

1. Mark with paint the provision of the corresponding forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

2. Remove a forward part of a loker of a wing.

3. Turn out bolts and plastic nuts (arrows on an illustration). For an element of a back part of a loker it is necessary to turn out one bolt and one nut on the bottom.

4. Take out back (1) and the top (2) elements of a loker of a wing from a wheel arch. The back element needs to be taken out under a cover on the bottom.

1. Installation is carried out in the sequence, the return to removal.
2. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers.