|
1. Open a back door.
|
|
2. Take out a clip from openings on a back cover. |
3. Enter a plastic wedge, for example, HAZET 1965-20 in the middle of a gap (the shooter on an illustration) between side and lower facings of a frame and disconnect facing elements from connections of clips.
|
|
Facing elements in this place are stuck together among themselves. |
4. Partially separate the lower facing of a frame (2) from facing of a door of a back (3), having strongly pulled for it, and applying a plastic wedge.
5. Pull a plastic hook from holders of a clip on facing of a door of a back. For this purpose enter the screw-driver into a gap between facing of a door and facing of a frame. Disconnect a plastic hook blow of the hammer to the screw-driver.
|
|
The plastic hook can break at the same time. |
|
|
6. Undertake a hand between facing of a door of a back and a door and pull strong breakthrough consistently 6 clips (arrows on an illustration). If it is necessary, use a plastic wedge. |
7. Remove facing (1) together with side facing of a frame (2).
|
|
The lower part of side facing has to be taken out from side facing at a back window by the movement from a window aside. |
|
|
8. Disconnect side facing (1) at a back window by means of a plastic wedge from 5 holders of a clip (2). (3) – top facing of a back window. |
|
|
9. Disconnect 3 plastic levels (3) from connections (3) and separate side facing of a back window (4) from the top facing of a window (1). |
10. Disconnect the top facing of a back window (1) strong breakthrough from 6 holders of clips (an arrow on an illustration) and remove it. |